Navigation

sail Online
Visited by mobile
back top

The Failure Form Of The Mine Car Wheel

Date:29/11/2018   View: 451   Tags: Mine Car Wheel Wheel Set Failure Form
Because the working environment of the wheel set is quite bad, the design is also flawed, and the mismanagement is not good, the service life of the wheel set is short. In the investigation, it was found that the wheel sets need to be overhauled and replaced with seals and bearings after being used for 6 months in the underground. In fact, the working load and running speed of the mine wheel on the down hole is not high, and the failure mode of the mine wheel pair is usually not caused by bearing fatigue damage.
Its main form of failure is:
1 Seal failure. When the muddy water with acid and alkali components enters the bearing raceway through the gap of the seal, the steel ball is blocked by the mud dust and is stuck and fails.

2 bearing failure. Since the bearing is stuck and does not rotate, causing relative rotation between the inner ring or the outer ring of the bearing and the axle or the hub, the axle is severely worn and stress is concentrated, and the axle is broken under the action of external impact load, and the inner circle of the hub Severe wear causes an increase in the clearance between the wheel hub and the outer ring of the bearing, causing the wheel to be excessively shaken and fail.

Menu

Hot News

skype sail Online Email:sales@chinacoalintl.com
menu
Home Products Top

+

+

Please leave a message


skype sail Online Email:sales@chinacoalintl.com
menu
Home Products Top

+

+

Please leave a message