1. Water connection: When the hose is put on the hose interface, it must be tightly clamped with hose clamp or iron wire to prevent air leakage and water leakage.
2. Use of mud pump hoses: When using high-pressure water hoses, the hoses with high pressure resistance should be connected close to the pump. After the water is filled, the hoses should be prevented from twisting or sudden bending, and the hoses should be prevented. Interface crash damage.
3, mud pump special hose connection: When laying water, to avoid sharp objects, through the main road when laying water, it is best to do protective treatment, through the road, should be dug deep to pass from below to avoid The hose was broken by the wheels and the water supply was interrupted.
4. Maintenance of the mud pump hose: After the hose is used, it must be cleaned, carefully washed and protected. In order to remove grease from the hose, wash it off with warm water or soap. The first thing you must do to melt the frozen hose is to use it, then wash and dry it. The hose that has not been aired should not be stored in roll.
5, the storage of water belt: water can not be placed on the outdoor sun and rain for a long time, as far away as possible from the heat source to prevent aging, to avoid corrosive and viscous material contamination, storage location, should have the appropriate temperature and good ventilation, do not use When the hose should be rolled up in a single layer, it should be turned several times a year and exchanged and folded several times a year. It should avoid mutual friction, and it must be exchanged if necessary.
6. Management of special water belts for mud pumps: There must be someone responsible for management to prevent unprovoked damage. All water hoses should be classified according to quality and numbered in order to grasp the use of water hoses.